Cyberstorm MK II in an A3000

[Prmetime]

Hi,
  I have been trying to install a Cyberstorm MKII in my A3000.  I had it running fine until I try to install the accel card.  When I do the computer will not recognize the hard drive.  I have the latest chips (WD rev8, Super Buster, Ramsey 7 DMAC 4) in the machine.  If I boot off of a floppy, the extra RAM on the Cyberstorm is recognized but the HD is not.  If I take the Cyberstorm out, everything boots up normally.  Does anyone have any suggestions?  
 :-?

[Prmetime]

Thanks for the help so far.  To answer all the questions,
 
I am using the SCSI controller on the motherboard.

I haven't reset the jumpers but I will look at that.
 
I thought the modifications to the motherboard were if you wanted to use the onboard SCSI for the Cyberstorm MK III.  I have a MK II which doesn't have SCSI with it so I didn't think any motherboard modifications were necessary.  Either way, I can see the RAM, I just can't see the Hard drive.

 As for the libraries, I used the ones that came with the board.  This board was used by a guy with an A4000D and he had no problems with it.  

So I shall look at the things you all have said and see if any of them will help.

 

[Prmetime]

Anyone have a manual for the Cyberstorm MK II out there?

[Prmetime]

@Amigabill

Currently I don't have anything and no one else is talking about it.  I'll take a scanned copy unless you want to deal with a paper copy.

[Prmetime]

I went digging through a CD-ROM that I got with the accelerator and lo and behold a file labled Cyberstorm MK II Manual.  It helps when you look in the proper places.