Workbench 3.0 problems

[Kvist]

Hi! I just got myself a harddrive for my A1200(Thanks Adonay!!).
So i tried to install WB 3.0 on it. The Hdprep goes just fine, it partition it correctly and everything.
Then i run the installer. After a while, it prompts for the Wb 3.0 diskette and run this up to about 10%, then i get the error:
Can't acces dos-drive, object might already be in use..
It shuts the installation down. And when i try to reboot with the diskette in, it runs for about 10 seconds and stops in Amigados with the number 1..
What to do?? It's frustating!

Cheers, Sigurd

[Kvist]

Tomas wrote:

It shuts the installation down. And when i try to reboot with the diskette in, it runs for about 10 seconds and stops in Amigados with the number 1..

That sounds really bad... It seems like it somehow tried to install on the floppy instead of the HD, which means your WB floppy is now ruined.
Always keep your valuable floppies in write protection.

I hope you have backups?
That is also one thing you should do when it comes to disks like WB, make copies.

If you have no backup, then i suggest you upgrade to 3.1 while you are at, since it works just fine even with kickstart 3.0 and has quite a few improvements over wb 3.0.

Yes, i have plenty of backups, so that ain't no pronlem.
It seems that you guys have sort it out, thanks alot!!
I would like to have 3.1, but i only have 3.0 kickroms, so i guess i can't install it.. :-(