A3640 in A3000D

[rkauer]

 Quoting The Big Book of Amiga Hardware:

V3.1

This card works fine in general however it does have a bug related to Zorro II DMA that causes some cards like the GVP Phonepak to stop working, when installed in an A3000. The PAL or GAL chip located at U209 should be -02.

Installation in an A3000

Though the size of the A3640 board fits perfectly even in the small A3000 desktop case, you can have some problem with the height. The earlier A3640s have a large heat sink on the 68040 CPU that would need some room in one of the two floppy drive bays of the A3000. Newer A3640s come with a flat heat sink that fits under the drive bridge without problems. If the heat sink of your A3640 is too high it may be necessary to replace it with a smaller one. One of the reasons why Commodore never recommended the A3640 for the A3000 is heat. The A3000 was designed to be upgradable with such a board, but the 68040 turned out to run hotter than expected and hotter than the A3000 was designed for. If you use the A3640 in the A3000 desktop, you always risk overheating the 68040 or any other part in the computer. This can cause errors, crashes or shorten the life of certain parts. To avoid heat problems, it might be a good idea to install an additional fan in the A3000. avoid using hot hard drives inside the case and not using it with high room temperatures.

The other thing to consider is the version of Kickstart your A3000 uses. If it contains Kickstart 1.4, the pre-boot Kickstart which loads a Kickstart image from disk you cannot use this accelerator, regardless of what version of Kickstart it eventually boots. If your A3000 uses Kickstart 2.04 then you can use this accelerator providing that you have a Ramsey Chip newer than revision 4 and you aren't using Static Column Fast-RAM. There are no known problems if you use Kickstart 3.1.

Jumpers

J100: CACHE & MMU at startup
Pins 1-2 Closed: Caches enabled
Pins 3-4 Closed: MMU enabled

J400: MAPROM

1-2 Closed: MAPROM enabled
3-4 Closed: MAPROM disabled