Mounting the chip is fairly simple. No need of a flathead screwdriver or an extraction tool, in that case.
1. Make sure you are statically earthed
2. Remove the card from your A1200 and place it on a flat firm insulated surface. (EG: Upsidedown mouse mat on a level table)
3. Note the proper orentation of the FPU, check all the pins are straight (look it up in the Amiga Hardware DB if not sure
http://amiga.resource.cx/exp/blizzard1230mk4)
4. Place the FPU carefully over the socket in the correct orentation (Remember, get it right, dont bend any pins)
5. Provide level, equal, firm & constant pressure to seat the chip into the socket. (You will feel a distinct drop as it locks into place.
As far as taking it out again.. Why?? It's found a home and should live there forever now.
@Xanxi, you have too many computers...
