Hi,
I was having trouble showing the bottom of the picture when using Visage with my 1260 Mediator/Voodoo system. After some messing around I found it was using a 1280 by 1024 resolution but when I tested that res in Picasso96mode it is only showing half the screen. This is on a Belinea (Eyetech) monitor which my wife has hidden the instructions to. I had a bit of a play and found that if I increased the clock Mhz I could turn off the interlace which then showed the full screen - but it flickers horribly.
Is it possible to use this mode so that I can see all the screen, or should I delete the mode from Picass96mode so that Visage is forced to choose a different one?
I can't seem to get Visage (or Picshow) to use the tooltypes/argumnets that I set. :-/
Thanks for any help.
