Author Topic: warp engine no manual help (Read 1738 times)

sarkis · « **on:** December 28, 2002, 12:53:10 AM »

hi all
installing the 72 pins for the first time .......
do the chips face towards the 50 pin scsi or the other way?
did the init2 a smitcheon of flux went on the main board is it a problem and how to clean a small amount of flux off the board...
tia
sarkis :-o

sarkis · « **Reply #1 on:** December 28, 2002, 01:25:11 AM »

Quote

shIva wrote:
first of all : you can not place a simm (i hope you mean them) the wrong way into the slot. for anything else have a look here
this might help you :-D

ty butttttttt.......
ive been to the page but it doesnt show the 4 simms installed
thx anyway
sarkis

sarkis · « **Reply #2 on:** December 28, 2002, 01:26:42 AM »

nbeen there but again no help with the placement of the 4 simms..
wont force them in

sarkis

sarkis · « **Reply #3 on:** December 28, 2002, 01:28:40 AM »

maybe yahoo has a generic pisture of a 72 pin simm holder and how to install?

sarkis · « **Reply #4 on:** December 28, 2002, 01:45:12 AM »

yahoo turned up generics to install 72 pin simms
sarkis