Welcome, Guest. Please login or register.

Author Topic: Wireless Netgear MA401 setup etc  (Read 2006 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline smiley1635Topic starter

  • Full Member
  • ***
  • Join Date: Feb 2006
  • Posts: 152
    • Show all replies
    • http://na@na.com
Wireless Netgear MA401 setup etc
« on: June 12, 2006, 05:42:00 PM »
Hi, I have bought a 16bit netgear MA401 wireless PCMCIA card.

I cannot seem to get wireless internet up and running.

I have plugged the card into my pcmcia port.

Then installed prism2.

I then open the shell and type:

SetPrism2Defaults SSID **** KEY ****** CHANNEL **

(*s used instead of real info)

I am using genesis tcp/ip stack. I run the wizard selecting prism2.device on device number 0. Then it says do you need a special config, I click yes. Then it requests a prism20.config. I cant find this. And then later on I get a device prism2 on device 0 cannot be found

This didnt happen earlier in the day when I tried it.

I also tried to install cardreset patch (is this needed?) but After adding the lines CardPatch and CardReset in the startup I get errors about CardPatch is not a valid command and it gives me a returncode of 10.

Any advice would be great,
 

Offline smiley1635Topic starter

  • Full Member
  • ***
  • Join Date: Feb 2006
  • Posts: 152
    • Show all replies
    • http://na@na.com
Re: Wireless Netgear MA401 setup etc
« Reply #1 on: June 13, 2006, 04:50:34 PM »
I found out that genesis only supports static ip address'

Im going to try MiamiDX