I need help to install CV64/3D on my 15" LCD Monitor

[Phantom]

I tried this weekend, but no luck. All I got was a message "Out of Range" (With Picasso96).

Before Picasso96, CV64/3D came with 2 disks (Install & Tools). So I decided to install them. I select 31KHz for monitor (I use a Sony 15" LCD), and I proceed with the installation. When it was finished I reboot my Amiga and tried to test some resolutions.

I've already connected my LCD cable to CyberVision64/3D and also the 1084S to RGB. On my LCD I can see the CyberGraphX logo. When I tried different resolutions, in different depths and so on, and pressed "test" my Amiga froze. All I can see is   the CyberGraphX logo with a nasty amiga pointer with some strange lines around it, and everything is stucked. I needed everytime to reboot my Amiga.

So I decided to install Picasso96. But anytime I chose a resolution (ex. 1024x768) always I got a message "Out of range". Please help me, this is going to drive me mad. What I'm doing wrong? :-?  :-?  :-(

[Phantom]

My monitor specs are as follows:

Sony SDM-HS53 15"

Max Resolution: 1024x768 / 75Hz

Max Sync Rate (V x H): 75Hz x 61KHz

Any ideas how to configure that in the prefs?

[Phantom]

If I'm correct, the minimum refresh rate is 50Hz.

[Phantom]

Thanks all of you. I will try this at night.

[Phantom]

Yesterday I selected a screenmode of 800x600 8bit and I got a chunky display on the LCD monitor, only the mouse pointer was correct. Is there any problem with the card?

Of course my Amiga froze again, so it needed a reboot.

[Phantom]

Sometimes it's freezing, and sometimes I press ESC to return to prefs.

I want to know if it's necessary to install the 2 disks that came with CyberVision64/3D before Picasso96 or it's not?

[Phantom]

No, no I don't installed them together, I just asked.