Enforcer

[tonyw]

I have a 4000 + Cyberstorm 68060. Although I have tried many times in the past and again several times recently, I have never been able to get Enforcer to "work". If I run it from WB or CLI, it says "Enforcer is on the job", but never anything else. If I run "Lawbreaker", it should cause a hit and print something out, right?

But I've never seen Enforcer print out anything except for the greeting message.

I remember when BB1 & 2 came out for 3.9, that H&P said you don't need to run "Move4k" anymore. Is this true? It doesn't seem to make any difference.

Any hints?

tony

[tonyw]

I've tried Cyberguard with the same result. When I run "Lawbreaker", nothing appears to happen. No fault report, no crash, no return from the task. SnoopDOS does not report any error either.

I haven't tried MuForce, although I have MuTools installed.

Maybe I should try Sashimi as well.

tony

[tonyw]

Thanks, guys. I didn't realise the output NORMALLY appears on the serial port, I thought it was only an option.

Duhh.

Where's my old Stinkpad?

tony