Hi,
I own a Turbocard from GVP.
Its Rev 3 RAM8 on this Site:
GVP 68030 RAM 8.
Its in my A2000 Board Rev 4.4 1MB Chip Ram, Kick3.1.
My Problem is, that this Card was only equipped with 4x1MB 30 PIN SIMM Ram's. I found some 1MB Modules an plugged them on the Card. But it does not recognize the new Ram. Workbench still reports ca. 4MB of Memory.
Does anybody know, if there are special Jumpers to set and where they are?
My second Problem is, that on my A2000 the internal Diskdrive is missing. So no internal Diskdrive is attached. But Workbench shows me a Drive Icon "DF0:
?". Does anyone know how to fix this? Can i use an A500 internal Diskdrive for my A2000? Or can i disable the internal Floppycontroller?
PS: Sorry for my bad English.
