Janus problems

[Crumb]

that's quite strange, the installer works faultlessly in 5 computers I tested (A2000, A2040, A2060, A4040, A4060T)...
My Janus version is 36.83... it must be installed in sys:Expansion
you should have the command BindDrivers in your Startup-sequence, so the Janus.library will be loaded.
Try to boot without caches to see if the janus.library loads... the CPU caches sometimes give problems with bridgeboards.
Check that the board is recognized (you can do this with sysinfo for example, if the board appears, it will probably work)

[Crumb]

Do you boot from an ide or scsi drive?
have you tried to boot without caches?
do you use the same janus.library version?

[Crumb]

just reboot with the two mouse buttons pressed, that should work.
There's a patch to make janus.library work with scsi drives (but I can not make it work), I think that as the janus.library isn't compatible with most of scsi controllers you won't make it work... I have a 4.3gb scsi and I have to boot from an IDE partition...
Janus.library does not get on well with DMA hd controllers...