Catweasel MK 4????????

[alltens]

I am not sure if this is the place to post this, but here goes.     What am I doing wrong???      I installed the Catweasel Mk4 between the floppy controller  and the floppy drive.  The software install went fine.  Now I can't see the floppy during bootup so the pass-through is not working.  Win Explorer can't see it either.  Therefore, I can't make a bootdisk to get into AmigaXL nor boot from it if I had one.  The imagetool can see the drive, but I don't know how to use it.  I want to dual-boot into either Win2k or into AmigaOS XL.  What am I doing wrong?

I haven't found any real instructions on how to use the Catweasel.  Can anyone point me in the right direction?

Thanks much.

alltens  

AMD64   3000
Abit KV8-MAX3
Win2k

[alltens]

Trev,
Thanks for the info also it is bad news for me.  When it didn't work, I tried adding a second floppy, but now the system can't see it at all.  I guess the other drivers are interfering with it.  I'll try and make a bootCD or even using a bootloader like OSL2000 to see if that might work.
BTW is there a doc that tells how to use the imagetool?  

If that doesn't work I will try uninstalling all of the drivers and re-install them in the 2-drive configuration instead of the pass-through configuration.

I really want this to work, but I am getting less and less optomistic.  I have a bunch of documents that I need to transfer from Amiga format to Word format.  

I'll let you know if I have any luck.

Thanks again.

alltens

[alltens]

Thanks for the info.  I haven't had a chance to get back to it, but I'll let you know what happens.  

I guess that this means that CrossDOS doesn't work with this setup.  No PC0:

Thanks again.

alltens