Who will be first??? Working MiniMIG v1.1

[Andeda]

Colin_Camper wrote:
I am building one using a V1.1 pcb from Nusim.

I have 95% of the components but there are still a few that I am having trouble with.

I am using a cheap temp controlled iron with a .4mm bit and .3mm solder and a bloody big magnifying glass!

As soon as I finish I will post my component list with RS and Digikey part numbers that I can verify are good (In both the mechanical and electrical senses).  :-)

 How is your project going? did you get all components   from digikey?

[Andeda]

Colin_Camper wrote:
95% from Digikey
I think I got the wrong SD card.
The memory, FPGA and 68k are all slightly different.
I guess I'll have to suck it and see!

Nearly everything I got from RS was not really right. E.g. the VGA connector was just the shell, etc etc.

I have my components on a spreadsheet - when I check the components I put a P for physical fit and an E for electrical compatibility. Obviously no components will have an 'E' until I build the board up and test it.

Im about to order the memory, FPGA, PIC and the 68K from digikey tonight, rest of the components ill try to find here in Finland.
Good luck, and let me know when you have a working minimig  :-D
Do you have a list of all components in the minimig and their values? did not find that on minimigs homepage?