Suggestion: Some more tutorials would be nice

[maffoo]

If that's all you're looking for, you can get the adapters dirt cheap off Ebay (eg. mobilesupply). You literally plug the CF card into the adapter and connect the adapter to the IDE interface just as you would a hard disk, then use HDToolBox to partition it.

[maffoo]

I see your point, perhaps a generic "how to install a hard drive in an A600/1200/4000" would be better though? The CF part is only a small variation, as there's very little to do apart from plugging it into a the adapter and setting it to master/slave (which is no different than on an IDE hard drive, so again would be covered in the generic guide.)

Might look into making such a guide tomorrow, if I have time.