Mugo wrote:
This HD is the only device in the chain. The cable is attached to the CPPB by a connector in the middle of the cable, and there's an active terminator after it (on the end of the cable), then the other end goes to the HD, that have termination enabled.
Let me get this right... it's like this:
TERM====CSPPC====HDD+TERM
Is that how it's set up? If so, why don't you try it like this:
CSPPC====HDD====TERM
The SCSI interface should terminate one end of the chain, so you shouldn't need a terminator before it. And maybe the terminator in the hard drive isn't working very well, which is why your transfer speeds aren't very good. If you put your active terminator after the drive, it may work better.
--
moto
