Installing Bvision?

[nasty]

Well i took my Voodoo3 out yesterday and replaced it with the bvision. so I fitted the bvision in the PT made sure it was all secure. did a fresh install 3.1 Installed my ppc drivers followed by the bvision setup disk, then installed OS3.9,mui,warp3d and checked the CGX screenmodes they were all there,which they where.then i went to the CGXMode to edit the modes and double clicked on it got an error message "could not open gadget.lib blah blah" so I added the lib to my libs drawer and then clicked it again and it listed all the screenmodes so i edited one and hit test, it said "couldnt open test screen" so then i checked my screenmodes again and they where all gone apart from the PAL screenmodes. so I rebooted the amiga and then got

makedir failed returncode 10
makedir failed returncode 10

then workbench loads with only the PAL screenmodes.

so anyone got any idea what went wrong?

[nasty]

B-vision PPC
V2.8
CGX V3 Release 70a

[nasty]

Piru your my new god ;-)

[nasty]

Nope I dont think I do, I own 2 bvisions but until yesterday I've never bothered with them. they have just been in the commodore museum loft. and i dont think they camewith any cd's just floppys disks


does anyone have or now where i can download cgxv42_r2_pre11?

[nasty]

Looks like i'll need to buy the CD before i could use the update.

Thanks anyway :-)

[nasty]

Well it looks like Im gona spend abit of time in the loft going through the bags and bags of amiga cd's and floppys to see if its there.

Since i dont have any manuals with the bvision is there anything i need to change in the settings to get the warp gears to work with the bvision like i have to change in powerpc settings for the mediator or does it just sort itself out.

[nasty]

Thanks Karlos :-D