I have an Expansion Systems Dataflyer Ram card and I can't get the thing to work. I was wondering if anyone had any suggestions on getting it to work as a stand alone card in a 2000 Rev4.4 I have tried the following:
checked all jumpers and they are as follows JP-2 closed, JP-3 Independent, JP-4 2&4
I have removed all the SIMMS except bank 0, so 2 meg and have those jumpers set correctly too.
When I run SysInfo it doesn't see the extra memory or even the card in the cards section.
The only thing that I can figure is that the 30-pin simms I have are 1x9 not 1x8 but I thought that it would just ignore the extra parity bit. I had it working on my 500 in the external case piggybacked on the dataflyer plus card but it won't work stand alone. Any help would be GREATLY appreciated. I am about to pull my hair out over this :crazy:
