I am having the same problem with my 4000T PCC card after the drive became corrupted.I made a sucessful boot disk however I still have boot problems after installing 3.1 complete with the PCC libs
I copied a 3.1 install to a 1.7 HD disk and coppied the PCC 040-060 libs to the libs draw. The new install disk boots fine however my problem is after making a clean install of 3.1 to my system partition along with the required PCC libs and rebooting the 4000T - right at the start of the boot process it comes up with software failure.
CAN ANYBODY HELP! ALSO has anybody made a boot disk with the 3.9 HD Toolbox instead of the old 3.1 Toobox.
I tried by copping over to the install disk the classes draw with gadgets and images which is required with the hdwrench libary and resource lib however when trying to open the 3.9 HD toolbox it complains it cannt open the resource libary even though it is there -Any thoughts
