Hi Folks,
this must be one of the dumbest questions on the forum, but here goes! So what exactly is required to run a 4000 desktop with two internal floppies?
I obtained a replacement for the origional HD floppy(DF0) from AmigaKit (not HD as far as I recall), everything fine so far. Then I managed to salvage another HD floppy from another 4000 and fitted this inside machine with Amigakit floppy - so now two internal drives physically connected. Problems start, if I insert a floppy into either floppy drive there is no power light coming on and no disk activity - but if I disconnect the floppy I/F from either drive the other one will work perfectly OK?. I tried adding a line to startup "addbuffer >nil: df1: 15" but all that did was to halt the startup sequence.
Any ideas etc. much appreciated, Ian
