HI folks,
I have a Maxtor 6Y080L0 YAR4 80G hard drive which I have installed in a A4000 as a slave drive. When I use HDToolbox it sees it and identifies it correctly and with a capacity of 76.3G, however ...... when I come to partition the drive although it show it as 76.3G at the top of the partitioning screen it only allows me to partition 20G, I have used the default setup so I end up with 4, 5G partitions.
I am running OS3.5, HDToolbox 44.18, FFS 45.1 and SCSI.device 43.3, I have not set any jumpers on the Maxtor to limit its size so does anybody have any ideas what is happening?
Ian