S/H Cybervision 64/3d...please don't say it's DOA!!!!

[RMK305]

I have a CV64 3D working in a A4000 with buster rev 9 and Cybergraphics V4. Are you able to try installing it on a clean install of workbench? I've never had any issues installing or unsing the card.

[RMK305]

I was watching this card also just to have as a spare. From looking at the listing again I wonder if he did infact know it wasn't working properly, or he couldn't get it to work properly,  hence why he only has the early diagnostic screen-but then I often tend to think the worst of a lot of people. I hope he gives you a refund but I suspect that it will be a case of it was working when I sent it as shown in the pictures.

Did you pay with paypal and a credit card? If so, you will be covered by your credit card company even if paypal are their usual useless selfs.

Robert

[RMK305]

Amiga Centre France or Anthony in NZ for possible repairs. I've used neither, but I'll be sending my A4000 to Anthony for the caps replacement sometime in the near future. Amiga Centre France is quite expensive from what I've heard from some people.

Interesting that you have had no reply as did he did say "I'm usually on-line at some point during the evening on most days."

Good luck.

[RMK305]

I hope you get it all sorted. £100? Bargain. One day I'll get a bargain like that, until then I'll just keep paying over the odds.