i would love to put my 1200 into a tower. But 250.00 is a lot of money for sheet metal. the only difference in a amiga tower and a pee cee tower is the back plate specially cut for the amoga 1200 motherboard. if one were to get a templet of the back of a 1200 motherboard drawn to scale, it would seem thay perhaps a mfg who makes towers and cases would cut the plates as needed.
just how many people would buy a plate for the back of a tower and install it, in a tower case of there own. the back plate of the tower is rivited in about 4 spots on each side of the case back a chisel would cut the rivits leaving a good hole to install screws securing the case back. just my two cents worth.
what do you think??? perhaps someone would have the tools and expertise to do the job themselves?
:-D :-?
i neglected to say i am in the usa
