Booting from 1230SCSI.device without HDD on the SCSI.device ??

[Mattijs]

I used to boot from my IDE HDD (SCSI.device).
This spring I bought a Yamaha SCSI-IDE bridge and I connected a second IDE-HDD to my 1230SCSI-controller.
The bridge works OK..., HDtoolbox could find the HDD, I could format it and I gave that partition the highest bootpriority so my Amiga started from that new HDD.

but..
Yesterday I disconnected the old HDD which was connected to the SCSI.device. But now, my Amiga didn't boot anymore from the HDD at the 1230SCSI.device (black screen).
When I re-conntect the old HDD to SCSI.device, my amiga boots again from the new HDD at 1230SCSI.device.

Can anyone help me?
Is it about jumpering the 1230SCSI.device??

Amiga1200T/060/SCSI;256Mb;mediator+voodoo3+SB+RTL8029;13Gb IDEHDD;Plextor W4012TS;yamaha SCSI-IDE bridge+40GbIDEHDD  
   

[Mattijs]

Hi,

Thanks for the suggestions!

 
I think the trick with Blizkick only works for the 2nd reboot?

The trick with the IDE-killer...mmm

Q: when I buy a IDE->CF converter and connect it to a CF card.... Is my amiga booting directly from my 1230SCSI??