Minimig PCB run - interest thread

[alexh]

little wrote:

how about adding a selector header (like the one that selects 15/31 khz) to select if the minimig has an active internal floppy interface or an active external parallel port? Chances are people will not need both (or at least will not use both at the same time)

I think Parallel port and external floppy disk drive are the the same connector.

http://www.amiga-hardware.com/download_photos/a500_4_big.jpg

If you had a minimig with this connector (and an FPGA with enough I/O) All you need is a different MiniMig "image" on the SD card to switch between parallel port or real floppy disk.

[alexh]

You might be able to use the AGL250 and above.