New Indivision 1200 AGA MK2cr *Pre Order At AmigaKit.com*

[giZmo350]

So, how is this new DVI connector mounted to the case, then? Please don't say "not at all"!

 I guess you'll have to dremel a hole to match the DVI connector in the small cover on the back of the A1200 Desktop and a couple of small holes to secure the connector with the cover screws. Or, drill a couple of small holes in the bottom of the case on either side of the connector and use a couple tie wraps. I rather liked the DVI connector circuit board cause there was a hole in it for a securing nut & bolt that matched an existing recessed hole in the desktop case bottom that worked perfect.

I also noticed that most all websites that sell the Indie AGA have been updated with the new model but, isn't the Vesalia site http://www.vesalia.de/e_indivisionagamk2.htm a direct contradiction with the new model NOT working with the 4000T? As opposed to what Jens says here...  http://eab.abime.net/showpost.php?p=890902&postcount=2216