Tweaked my A3000D

[sandpiper]

@Zac67

For the Warp Engine's SCSI to work you need the INT2 mod.

The WarpEngine uses its own workaround instead of the INT2 mod. There is a jumper wire that you need to clip onto pin 21 of CIA U350. I think it performs the same function as the INT2 mod.

[sandpiper]

@T3000

The scsi header on the WarpEngine for some reason hadn't worked the number of times I tried to make it function.

I found that when I first installed my WarpEngine that the SCSI controller wouldn't work either. The A3000 wouldn't even boot if the WE SCSI was connected. After a lot of heartache I found that the WarpEngine did not like the hard drive that I was using. It was an old Quantum SCSI I drive. I found an IBM SCSI II drive and it worked fine.