Trump card actually works right now. I took a 4gb hp hard drive to it, from another amiga.
Trump card manual says that it doesnt need a terminator unless cable is long, something like 70cm. I dont have any active terminator or cables to use with them. Only 3 connectors per cable.
Currently I use cd drive as a terminator.
I ques that I try to set up those drives with GVP scsi controller and see what happen.
I did change a scsi.device name to correct one to hdtoolbox.
What about that "no wide scsi" jumper, should I put it on or not?
Thanks
the cd drive is a good terminator-make sure it is the last physical drive on the cable. Set the "no wide" jumper-this will terminate the high bytes on the drive so it works with narrow scsi properly..
These old cards weren't made to run with big drives but i should think it would see it.
try the trumpcard tools(do not LOW LEVEL FORMAT IT!) this is not the same as a amigados format.
Make the partitions 2gb or less each and you may not be able to use more than 4gb total on the trumpcard with the drive(not sure).
the disk can be found here:
http://amiga.resource.cx/exp/trumpcardpro2000
