Mediator PCI + MOS Powerup: got RTL 8029 working!

[Boot_WB]

That's really good news!

I look forward to giving it a try - I probably would not have thought of setting the memory window jumper to 0mb.

btw - you could always run a switch from the jumpers to the front panel that would allow you easy access to switch between the 8/4/0 mb memory window settings.

[Boot_WB]

@Amigaz

Dragging up this old thread, did you try setting the "swap config" jumper on the mediator card to closed?

According to the manual, this is the setting to use if you are using a Z3 graphics card. Perhaps this configures the mediator for using i/o cards which do not require a voodoo card for DMA buffer?

Unfortunately, I don't seem to have a RTL8029 card around any more (I'm sure I had one somewhere..) so I can't test it myself.