fitting a thermal sensor to BLIZZPPC

[adonay]

the best place would be out of the air flow of the fan, for a more reliable job.

this is not quite true i have been overclokking computers for years and to get the best reading you should lift off the heatsink place the ultra slim sensor on cpu core in a corner or so then clean off the old cooling paste and apply new..this way you get the best reading..

does drilling a hole also apply to the harddisk drive or can i put the sensor inside..

the place were you have got the round engine mounting in middle of disk plase the sensor over there will be the hottest part.. :-)



adonay :-D

[adonay]

sorry i did not make my self too clear i did not meen on top off core since you need 100% contact with core and heatsink but on the side of the core near a corner..
if you are unsure dont do this..


adonay :-D