Red got me last week with his free shipping...my new Indivision A4000 arrived this afternoon. After packing in the work I'd been doing (it will wait until tomorrow) I took my A4000 out of storage and installed the board.
I hadn't used the A4000 for a bit since I sold theScanMagic I'd been using for it last fall. Boy am I glad I pulled the ScanMagic. It's replacement is MUCH MUCH better!
Installation was simple, the only problem I ran into was putting enough pressure on the board to seat it properly on the Lisa chip. First attempt didn't work, I went back and got the board to pop on and it worked fine from there. Upgraded to the 1.4 firmware and all is good!
Great board, thanks Jens!! Good to have my A4000 back again!!
Bob