Hi, I need some help with my Picasso II+ board in my A4000.
I’ve moved it from my A2000 to my A4000 so I know it’s working fine.
I’ve installed the board and ShowConfig says its there: Board (Village Tronic): Prod=2167/12
I’ve Installed Picasso96 and the Picasso monitor driver is in DEVS:monitors but no modes are available.
If I run Debug it comes up “No Board”
If I run Picasso96 as suggested in the guide I cannot attach a mode setting to the device as it comes up “No Board” in the menu.
Something simple I’m sure,but its about 6 years since I last did this on an A2000, as well as me being tired and going to bed now.
Help appreciated.
Cheers.
Gertsy.
Hi,
@gertsy
Do you have the special plug that comes from the back of the Amiga 23 pin connector that goes to the Picasso II board. The plug should feed in from the Amiga 23 pic connector to the Picasso II boards inner plug, the VGA plug should go to the outer plug on the Picasso II board. If you did this then try redoing Picasso 96.\
Remember the Picasso II board needed a video input from another board, I am using a GVP IV24 board to feed my video input.
smerf
