motorollin wrote:
I've spoken to Matthew at Amigakit and he reckons the socket isn't connected firmly over Gayle. I didn't remove the motherboard from the case before fitting so couldn't push down very hard to fit it. I'm going to try removing the motherboard and see if I can get it working out of the case, then rebuild everything.
Very likely, had exactly the same thing happen to me. The edge of the socket that goes over gayle should indeed touch the motherboard on all four sides, however it doesn't always snap in place. Also check the seating of the board in the ROM sockets, these are prone to work their way out, that is just why elbox supplied a tie-wrap...
