The MiniMig PIC update issue thread

[Anding]

Thanks a lot for that tidbit. Checking the ports in my settings revealed the COM ports were set to 9600 baud. However, after setting them to 115200 I get the exact same results. Both on my workstation and the missus' PC.

Do you need to push the baud rate up so high?  I have a little experience with building embedded hardware and find there is always a trade off between coms speed and reliability, especially if a poor connection somewhere is exacerbating the problem.

Would you try and set both sides to 9600 and give it another go?

[Anding]

Odin22,

Given what you've already tried, if I was in your shoes I might be tempted to send it directly to ACube under warranty now and save time?

Good luck anyway,