I am having a problem with my CyberstormPPC enabled 3000T. With the card installed I cannot boot off a SCSI hard disk.
Machine specs:
Amiga 3000T
CyberstormPPC @ 233 MHz
2MB chip RAM, 72MB fast RAM
OS 3.1
Scenario 1: Connect one end of the SCSI cable to the on-board SCSI, hard disk in the middle, terminator on the end.
Result 1: Nothing happens. Holding down both mouse buttons and looking at possible boot devices only shows me DF0. SCSI disk is invisible to the 3000.
Scenario 2: Connect one end of the SCSI cable to the CSPPC SCSI, hard disk in the middle, terminator on the end.
Result 1: I can see the drives in the boot screen but cannot boot the OS.
I have installed the OS and Phase 5 drivers. I can boot the hard disk without the CSPPC in place. I can boot the OS via floppy if no hard disk is plugged in. But once I try to boot off the CSPPC/hard disk combination I have problems.
Is there something I am missing or should have done?
Thanks
