DENEB on G-Rex4000D , DMA non working issue...?

[keropi]

Hiya!
today (finally) I installed my 1st DENEB on the g-rex4000 A4000... I removed the kickflash/subway combo, installed DENEB and PSD4 on top of 3.8 ... I chose the DMA driver, the card went online, but no USB device would work... When inserting a usb-flash-disk I get the usual pop-up for it, but it won't show up in wb, and there is a complain about bad blocks on it...
selecting the PIO driver on the other hand makes everything work OK
plus I got some yellow gurus on startup too after the intro, I had to completelly erase the flash  :lol:
is there a solution to use the DMA driver?
this A4000D has a rev11 buster, a 233mhz 060/50 csppc, the grex4000D and a voodoo3/3000 , the test config... (will later add the lan/sound card on g-rex)
anyone else tested a DENEB on g-rex4000D?

[keropi]

@mboehmer_e3b:

no , I don't have the original zorro busboard... and I naver tried any zorro cards on the g-rex, except the kickflash/subway combo...
I am waiting for a 2nd DENEB to use on my other A4000D, it has the same libs/csppc but with a picassoIV+goldengate486slc cards...

@Michael_D:

will give it a shot, I now use the g-rex 060 libs and oxypatcher  :-)

[keropi]

no, I bet this happens simply because E3B does not have a g-rex4000 to test...  :-D

@mboehmer_e3b :

if you have a csppc, I can send my g-rex4000D to test DENEB  :-) (but only as a loan g-rex, I cannot part with it  :lol:  :lol:  :lol:  )

[keropi]

just updated the DENEB flash to v9 , the DMA driver still gives problems...  :roll:  
Flashlab, did you try it too?