CS-PPC on 4000, no boot, nothing...

[keropi]

I just installed my csppc on a 4000.... it powers on and the screen just stays black... I put a 030 card on, it works fine... also tried with pressed 060 ...
is the cs-ppc dead?  :boohoo:  :boohoo:

[keropi]

jumpers where both to INT, made them to EXT
there is an IDE HD, and on the csppc matching 32MBx4 Simms... still nothing, no ESC or S.... still no-go...

[keropi]

The HD that is on, was the same from my 060 BPPC.
also tried to have the os3.9 emergency bootdisk inside the floppy , it does not even try to read the fdd...

[keropi]

but how can I install the libs??? I cannot boot, cannot enter Early startup menu, cannot enter csppc menus either....

[keropi]

the green led just stays on, never blinks...

[keropi]

tried a new os3.9 installation with the 030 card. installed also the libs from the p5 unofficial support
site.
removed the whole a4000 mobo to see better the mobo-csppc allignment. all work OK with the 030.
removed 030
insert ppc, look, it locks fine to the slot.
power on
nothing...
after ~10 capslock on/off the capslock stays OFF...
also tried WITHOUT csppc spacers, the same...
according to patrik that indicates a faulty 68k side? so it is dead?
should I return it to the seller?

[keropi]

actually redrumloa is to be cretited for the caps lock check... I am too confussed over this disaster...