Powering both the g-rex and zorroII bus on a 1200, advice needed...

[keropi]

I have an RBM tower, and in order to use the BPPC + g-rex I must also keep the zorroII busboard... all fit PERFECT inside, but I am a little worried about powering the g-rex...
Can I safelly take one connector from the busboard and put it on the g-rex?
will it cause any trouble?

Thanx!

[keropi]

are you sure? the g-rex also has a connector like that, but on the installation manual it says to connect just one...

[keropi]

well, the zorroII is there ONLY for providing a place for the ppc to connect to, no z2 cards will be used, and the amiga won't even know there is a z2 busboard present  :-D
and putting the "good" power line on the g-rex is a bad idea, because the z2 powers the ppc card, which draws more power... anyway, I have installed it with the way I described and everything is OK (I asked a couple of friends on #amigahellas that have g-rex's first...)

EDIT: NOT by removing the plug indicated with an arrow, but with the aid of my cable... be carefull!