I am trying to install 4.1 classic on my A4000 with CSPPC, CVPPC, Adriana netcard and Tocatta sound card.
The problem is that when I try to boot of the boot floppy with the CD inserted it boots the floppy and starts to search the CD, resets (as it should) and then starts to load from the CD again. The screen (on my CVPPC) however stays black and after a short while it resets again and start all over. And it goes on and on.
I have 3 HD's, 2 CD's and a ZIP-drive connected to the SCSI.
The systen boots OS3.9 fine from HD and form an emergency boot floppy also so that part works.
I have tried to start the installation of 4.1 from OS3.9 but the error is the same. Is it something with my SCSI setup? I have just bought the machine so I can not say in details how it was built and my SCSI-knowledge is rather low - to say the least.
The drives are as follows.
Units:
Board 0 - Unit 1 - IBM DRHS36D 0110 33,9GB - where I want to install 0S4.1 to
Board 0 - Unit 2 - CD-ROM PX-32-TS
Board 0 - Unit 3 - HP35470A (ZIP)
Board 0 - Unit 4 - CD-R PX-W124TS
Board 0 - Unit 5 - Seagate ST150176LW 0001 46,5GB - where OS3.9 is installed at the moment (boot)
Board 0 - Unit 8 - Viking II 4,5WSE5520 - planned to install MorphOS here
Any suggestions?
My PPC works fine. Can play WipeOut for ages without any problems.
Thank you in advance.
