Hi, I need some help with my Picasso II+ board in my A4000.
I’ve moved it from my A2000 to my A4000 so I know it’s working fine.
I’ve installed the board and ShowConfig says its there: Board (Village Tronic): Prod=2167/12
I’ve Installed Picasso96 and the Picasso monitor driver is in DEVS:monitors but no modes are available.
If I run Debug it comes up “No Board”
If I run Picasso96 as suggested in the guide I cannot attach a mode setting to the device as it comes up “No Board” in the menu.
Something simple I’m sure,but its about 6 years since I last did this on an A2000, as well as me being tired and going to bed now.
Help appreciated.
Cheers.
Gertsy.
Try it in another Zorro slot, in fact, keep trying it in every Zorro slot you have until you have tested it in every Zorro slot you have and confirmed that it behaves the same in all of them.
