Ok - hardware hacking time!
I'm going to connect an A2000 040 board to my A1000.
After seeing http://www.a1k.org/forum/showthread.php?t=6592), and comparing those notes with other Zorro data I've gathered there's just a few things that aren't 100% clear.
The schematic is clear enough with regards to connections, but I need confirmation of the following (babelfish translation isn't 100% clear)...
"Ich hab an diesem Baustein alle Pins, genauer gesagt, den spitzen Teil
abgekniffen, AUSSER den Pins 1,2,3 und 7 + 14.
Am 74LS08 müssen dann die ungenutzten Eingänge 4,5,9,10,12,13 über einen
feinen Draht miteinander, und dann mit Pin 7 verbunden werden.
Den Chip hab ich dann auf den TTL-Baustein, der vorm DENISE liegt, aufgesetzt
und an den Pins 7 + 14 miteinander verlötet. So hat er + 5V und Masse."
What exactly is the above quote stating?
It translates to:
"There's no fraking way you're going to get that 68040 accelerator working from the side slot expansion on the A1000!"
:laughing:
(just messing with you and kidding around)
I can't translate it for you, but have you posted your question on the A1k forums? They have several people there that could do a much better job explaining in English.
Hope to see your results of your project. The A1000 is the coolest Amiga case design.