Well two topics in one really...
I have a 12GB 2.5" Hard Drive for my A600 - I haven't physically put it in the Amiga yet but have been practicing on WinUAE so I don't make any mistakes. However when I boot from the Install Disk it doesn't allow me to partition the drive. It also asks me to do a low level format - as I will be using an IDE drive I don't want to actually do this. I wondered about the correct way to do this?
Also my Workbench disks are broken - I do own them - and can take pictures to prove this - I have the ADF images but need them written back to disk. I would, obviously, pay for the priviledge or provide some small piece of hardware (DVD drive / Replacement Floppy Drive / 128MB PC2100 memory and prove that I own an Amiga / Workbench before you make the disks for me. But anyway to cut it short I would like someone to write the disks back for me and post them to me (UK).
You can email me: maccaz (at) dsl (dot) pipex (dot) com
Obviously substitute the at with @ and the dot with . and no brackets () or spaces.
I've seen a few websites that would do this but they are too expensive and cost more than the Amiga itself would cost(£25 for a full set).
If anyone could help me out on any of the above I would be most grateful.
Many thanks,
Macca
