Hi LinchpiN,
In what way? Battery removal and...?
Ok, here goes (you asked for it):
First, the whole Amiga 2000 computer was dis-assembled. Then the battery was very carefully de-soldered from the motherboard. The dust was blown off the motherboard with compressed air. The Zorro II, CPU, and Video slots were carefully cleaned with a Super Nintendo cartridge slot cleaner (it works great). Next, the top cover on the power supply was removed and the dust was blown out with compressed air. The 80mm fan was replaced with a new fan that was made in Japan (very high quality). The power supply/drive chassis was wiped clean with a 100% cotton rag and WD-40 and then wiped again with a clean dry towel. The inside of the case and cover was also wiped and cleaned with WD-40 (WD-40 reconditions metal and gets rid of moisture and helps prevent rust). The old cork feet were removed from the bottom of the case and replaced with 5 new feet. One of the few problems with the Amiga 2000 was that it only had 4 feet and the center part of the bottom of the case was not supported. So, this would cause problems. These problems are fixed by adding a foot to the middle of the bottom of the case. Finally, the Amiga 2000 was re-assembled. All of the old metric screws were replaced with brand new ones. The front plastic part of the case was then carefully cleaned and the famous Amiga 2000 label carefully reglued and polished. Then I put this Amiga 2000 through extensive testing to make sure that it works and that it holds up to its proud heritage of being a Flagship Amiga computer. The only thing left for me to do is autograph the underside of the cover. :-D