a3k keyboard problems

[koaftder]

I have an a3000d with a keyboard issue. I have the same results with a Lyra ps/2 adaptor and a commodore amiga branded keyboard with the large DIN style connector. With the system powered off for an hour or two I get keyboard input. Anywhere from 10 seconds to 10 minutes it starts sporadically dropping keys and repeating letters then stops working all together.

CTRL+AMIGA+AMIGA always resets the machine despite not being able to respond to keyboard events. I suspected the CIA could be a problem and since I have two on my system I swapped them, same problem. I have another pair of CIA chips which I tried and still get the same problem. With the keyboard disconnected the clk and dat lines to the CIA are pulled high as indicated in the schematic. With the keyboard connected the clk line to the CIA is 4.8v and the dat line is 1.2v.

My internal and external floppy interfaces are working properly.

So far I have confirmed the following:
1) My keyboards are in good working order
2) The CIA chips are in good working order
3) The pullups are in spec
4) No bad traces from the KB physical interface to the CIA

Any tips on where to proceed from here? Is there any specific documentation floating around about how the CIA works? Upon receiving a keyboard event, does INT2 fire off?

[koaftder]

Thanks for the tips guys. I have good power to the KB interface and no corrosion/gunk in the sockets. I have less than one ohm of resistance from the clk and dat lines on the kb interface to the CIA.

I'm using an ATX powersupply on the a3k and have it set for vsync on jp350.

[koaftder]

I have also chilled each chip on the mobo while fired up with a can of compressed air upside down and still no kb capability after running for a minute or so. ):

[koaftder]

my tic signal from vsync is 190us in width with ~16.5ms spacing in between upon startup. As the machine warms up it gets erratic and I loose kb functionality.