DKB 3128 only recognises 64Mb

[amiwalker]

I had the same problem!

GET "FAST PAGE SIMMS" not "EDO"

All will be fine.

The documentation says that EDO will work, but it didn't for me. So I installed Fast Page type and volia!!

[amiwalker]

A3000D, WarpEngine 040 with 64M on board
DKB3128 with 128M on board
Still using motherboard SCSI (couldn't get the W.E. to work)

Chips - Buster 11 DMAC-2 RAMSEY 4

HDD - 4.5G and 1.1G

X-SurfII

Spectrum 28/24 Gfx card (using CGX 4.2 sw)

[amiwalker]

Yes I did the int2 mod myself. Still could not get the WE SCSI to boot any Drive attached to it. All that would show up was the hand with the floppy.

I basicly gave up on it and continue to use the motherboard SCSI.

I thought it might also have something to do wth only having DMAC-02 instead of DMAC-04.

BTW try to get a DMAC-04!!!!! Good luck!!! I have heen looking for some time now and no one wants or has one to sell to me.

[amiwalker]

Take note that there may be some Zorro address conflicts depending on the which zorro socket the  board is placed in conjunction with the other boards attached.

My A3000D has the following config

Top

DKB3128
Empty
Spectrum 28/24
X-SurfII

Bottom

Hope this info is useful for someone!