Hi guys,
I have decided to design a housing for the FPGAArcade Replay.
Some of you maybe remember I did a few runs of minimig housings.
There will be two kit versions of cases including spacers and bolts.
The cases will be made from Plexiglas just like the minimig cases.
Versions:
1. For the FPGAArcade Replay mainboard.
2. One for the FPGAArcade Replay Including the 060 daughterboard.
This version will include a sunroof/hole for the processor so the heat sink can vent out the top op the case (only the square heat sink will be supported)
both version will have a engraving on top on the case just like the minimig version.
I have permission to use the word FPGAArcade Replay from MikeJ but any other suggestions are welcome.
I have broken my leg on three places so I have some spare time in thinking over a disign ;-)
I'm one of the lucky ones to purchased on of the first FPGAArcade Replay boards (from the first production run of ten promo boards), So I like to say thanks MikeJ for that.
When I receive the FPGAArcade Replay Board I will start the design of the main board version and make a prototype.
The version including the daughterboard can only be done after the redesign of the daughterboard MikeJ is working one at the moment, because I have to know the final placing of the processor on the daughterboard and the hight of the two board installed.
So any suggestions are welcome.
Prizing is not available yet but will let you know after the prototype is ready.
You can also let me know here if you are interested.
I will keep a list after the prize is known for the kits.
Pictures Minimig cases previous run below.
|
Just curious, I'm building an Amiga emulator PC from a micro atx mobo. I had the idea of creating a simple plexiglas case very much like your minimig one. How did you cut your plexiglas? - with one of the special knives? - or with a jigsaw, or what?
