Enable ram on Harms Professional 030 Plus

[lillPiP]

Hi all!

I really need help to activate the ram on my Harms Professional 030 Plus to my Amiga 500.
I am trying to use the ADDMEM-utility to activate any ram on the board. Unfortanely the computer locks only.
I have tried to set the jumpers differently and even trying to decrease the amount of ram but with no luck.
Trying to use the AutoAdd found on Aminet, activates the ram and configures it but only to crashes soon after.

I have downloaded the Utilitydisk for the Harms-card, and when rebooting the computer and running up Workbench it soon crashes =(

I am probably doing something wrong.
Any ideas?

It is really annoying!

[lillPiP]

How should I type the command together with AddMem?

I have for now 4 mb on it. I had 8 MB first but I tried to remove half to see if that would be of any help.

For 4 MB I have used the following jumpersettings: 1-0-0 and 1-0-1. on Pins 2-4.

I got some sort of jumperconfig here on Amiga.org I have been using to try with.

But if you have more info I will be more than glad

[lillPiP]

Thanks for the info!

I managed to get the ram ok now!  :-D

I seemed that the other configuration I had was a few numbers short, but I solved it. Finally!