FAT95 and removable SD Card

[AndyFC]

I've got Fat95 running which I'm using to read and write files to an SD Card, using an SD to IDE adapter. I've mounted this so the card slot is accessible from the front of the tower. My mountlist in DEVS (built using MountDOS12) is called SD0

The only 'problem' is that if I don't have an SD Card in the adapter when WB loads I get SD0:NDOS and putting the card in after this means it isn't recognised. Similarly, if I have a card inserted when I boot it is seen but if I remove it, the icon stays and workbench hangs if I double-click it.

Is it possible to dynamically mount and unmount the SD card when it is inserted and removed?

[AndyFC]

Thanks Kolla - I'll have a look later in the week when I get a chance.

Last night I tried automount from aminet but although it ran and detected the drive there was no status change when the card was added or removed (I tried with and without the mountlist in devs). I suspect the issue is that the SD to IDE adapter is always being seen as the 'drive' and so removing the SD Card isn't taking the whole device out, therefore 'SD0:' still exists.

[AndyFC]

I've had a look at this tonight and:

- Changing the Activate tooltype to 0 does allow me to only see the card when accessed
- Using the Assign ... dismount commands mean the card can be removed - this is fine for me if I just stick with the same card

There is still an issue if I boot to WB without the card inserted or if I remove the card and re-insert. Trying to access it if the physical card is put in the SD card slot after WB is loaded means stops it being mounted - this is probably a hardware limitation.

However I am happy with the fact that there's no longer an SD0:NDOS icon if I boot without the card so that's good enough for me.

Thanks again for your help.