Subway and Indivision A1200 Desktop

[delshay]

portarinos wrote:
Well done Amigakit!  Really nice job. I'm looking forward to receiving my Subway + specially made clockport cable from E3B (Subway will be fed by my internal pico psu as the m/b lacks two clockport pins  :crazy:  and the card can't be fed "normally") and will try to do the same. Such a pity that it doesn't have at least 2 usb ports.    

iv also fitted the INDIVISION to my A1200 its glued & locked the A1200 motherboard but is powered by the 3.3v using the PICO PSU 3.3v ( regulator removed off INDIVISION ).

output is done via a 15pin VGA socket also on the motherboard.

[delshay]

amigakit wrote:
We are designing a lower profile PCB that will accomodate two USBs with the Indivision's VGA connector so this may squeeze in another port for the standard A1200 desktop without modifying the case,

please take into account the plastic insulator of the USB lead as you may not be able to use both slots if adding two ports as above in the same place.

maybe turning the USB port on it's side may help.

there's also the monitor lead plastic insulator good luck with your modifcation.

[delshay]

i was thinking a good place for the SUBWAY unit is where the mouse sit's. if you have a motherboard rev 2b you could mount the card there & move the mouse interface some else.

you can replace the mouse with a RF mouse ( wireless ) using the ten contact points on all A1200 motherboard near the mouse port just by adding 10 pin socket.