Cybervision64

[Morley]

Has anyone got a PDF version of the original manual for the Cybervision64 (not 3d version!)or can tell me where to get one? I did a quick google and found nada!

I'm trying to set the jumpers on the board, I need to set JP1 to buster v.11 mode, but the jumpers on the board aren't marked.

Thanks in advance!

[Morley]

@framiga

Thanks, just what I was looking for!

[Morley]

Apache2k wrote:
Hi
I found in the internet a very nice place and so far it also looks very LEGAL. Its mostly in german but you can get some information from the pdfs.

DCE

br.Apache2k

Sorry, those were for the 3d version only. But nevermind, I got the needed page from framiga.
Thanks anyway :-)

[Morley]

TjLaZer wrote:
Can I get a PDF of this for the CV64 also?

Thanks

Check your email :-) just a jpg scan though.

[Morley]

@framiga

Haven't done any speed-tests yet, but it sure is faster than AGA! But I only have a stock C=3640, so it is not as fast as it could be I guess :-(

[Morley]

@tjlazer

pmail me your email, and I'll send a scan to you (from framiga)

[Morley]

Picasso works fine for me, the only reason I installed it was because I'm used to it from Winuae. Maybe I'll test CGX some day, maybe not...I don't have the original disks or manual, but I guess CGX3 is only works on CV cards so it is free anyway.

[Morley]

Any of you guys now a good pic-viewer? Viewtek and fastview only gives messy gfx, and multiview is to slow..I want a program I can force into only using GFXcard modes, and which is ideal for browsing through loads of pictures. (Just like good ol' fastview...)