Hi guys,
i recently bought a untested external floppy drive, power computing with a sony mpf 410 inside.
On the pcb there is only one switch with the options 0,1,2,3.
I chose 2, as i plugged it to my other external drive and the drive was spinning but nothing more than this..
Then i did something stupid! I changed the switch to 1 and since then chaos..
1.Cannot open atapi.device unit 1
2. Ituition is attempting to reset the wb screen. Please close all windows except drawers.
3.When i'm trying to test every drive in sysinfo a get a guru 800 00B task 00344608
4.Even though only the internal drive is connected, the screen is showing every drive on as df0:
? df1:
? df2:
? df3:
?
5.The drive led on the A500 keyboard is always on, even if there is no floppy inside and the led of the drive is always off even if there is a floppy inside. (I have my A500 in a tower)
Any suggestions please..?
